VD909 has 3 sensitivity outputs
10V - 30V AC/DC
NO COM NC
PULSE ONLY
Sensitivity Inductor Pack INCLUDED
Exit Sensor with 18m Fly Lead & Module

NO GOING NC 

Description

Diablo VD909 Mini Exit Sensor & Module Kit

Exit Sensor & 18m Lead

The ‘Dynamite’ mini loop is a unique vehicle detector device in a 22mm diameter tube.

An integral ground cable runs back to a module in your control panel. Dynamite gives a pulse output when a vehicle drives over. It is not a safety device

Diablo VD909 Mini Exit Sensor & Module Kit Simple installation

Drill a 25mm hole in the middle of the driveway for the yellow sensor, then cut a shallow slot for the cable from the hole directly to the control panel (no need for loops to be cut). Connect to the small module in the control panel which has auto-setting. Fill slot with road repair material. It really is that Simple!

Basic Installation Guide
Installation is straightforward. A 1-in. diameter hole (18-in to 24-in. deep) is drilled for the “Mini Loop”. A shallow, 1/4-in. saw cut from the hole to the edge of the road provides a path for the lead-in wire. The “Mini-Loop” with lead-in is inserted into the hole and the hole is filled with dry sand. Detector Loop Sealant material is then used to fill the slot and top portion of the hole. It is important that the “Mini-Loop” be installed in a vertical position and that the vertical position of the “Mini-Loop” be maintained. Under some soil conditions, installation can be further simplified by installing the Mini-Loop inside a length of PVC pipe (not steel pipe) with an interior diameter of about 1 inch. In this case, the hole must be slightly larger than the outside diameter of the PVC pipe, typically 1-5/8-in. or less. After insertion of the PVC pipe and Mini-Loop, all cavities are back-filled with fine, dry sand and the installation completed in the normal manner.

Detection Area
With most vehicles, detection will start at approximately the front bumper and end at approximately the rear bumper. Oddly shaped vehicles such as bicycles and trailers may appear shorter to the Mini-Loop than their actual length. For example, some bicycles detect only for a short period of time near the middle of the bicycle. Aluminium or fibreglass trailers will likely detect only for a short period of time around the axle and suspension. These characteristics are very similar to those of a 6-ft. X 6-ft. loop. The primary difference is that the Mini-Loop in itself is only a point rather than a 36 square foot area. This allow

POWER OF CONTROL PANELS

F4+/F4   20+/21-     AC
BA230    16-/18+.    AC
BA24      14-/16+.    AC
BE24        9+/10-      AC
SC230E   14-/15+    AC
SE24.        7+/9-       DC
BR24.        34+/36-  DC

WIRED INTO START

                NO / COM
F4+/F4    19/13
BA230     20/32
BA24       18/29
BE24.       17/23
SC230E.    9/13
SE24.        19/17
BR24.        24/33


CALL ADRIAN FOR MORE INFO 07971475781